Tuesday, 12 February 2013
BMW LCD COMMUNICATIONS-INSTALLATION MANUAL
When you have set up a permanent location of the source of the alarm control unit and battery, as defined in the door switch in the vehicle type used, you must specify the source connected to a 12 volt power supply. This is usually found in the power switch wire harness and shows constant voltage, when the key is in the "on" and with the engine running. The voltage source must be removed when the motor and power supply connected to the "Off". When the set is connected to a 12 volt source, search the vehicle parking lights to the wire. This wire is usually used for the light switch in the back or some handy light is installed in the vehicle, which is easily under the hood in the front. The correct wire displays voltage, when the light switch is turned on to its parking position and the lights. If this installation instead of a siren, the vehicle Horn honk the Horn line, locate the fuse block or the main harness fuse Block.
MANY OF THE HIGHLY TECHNICAL NATURE OF THE RESULT, WE RECOMMEND THAT YOU TAKE ADVANTAGE OF THE VOLTMETER TO CHECK ALL THE ELECTRICAL CIRCUITS OF THE VEHICLE INSTEAD OF A COMMON TEST LIGHT! Test the lights can cause damage to the vehicle computer if the wrong wires have asked and can cause safety cushions to activate (use). Either the above cause extensive damage to the vehicle, which reads. Pay attention to all Warning labels on the vehicle. Automatic page creation to assume does not match at all, or other vehicle damage or personal injury caused by improper installation. Professional installation is recommended for RF-520-security system. View full details on limited lifetime warranty.
Download